G-code: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 5: | Line 5: | ||
*G90 - set absolute positioning | *G90 - set absolute positioning | ||
*G91 - set relative positioning | *G91 - set relative positioning | ||
=Filament= | |||
*M404 N2.85 D1.0 - 2.85 mm filament and nozzle Diameter of 1.0 mm | |||
=EEPROM= | =EEPROM= | ||
*M501 Read all parameters from EEPROM. | *M501 Read all parameters from EEPROM. | ||
Revision as of 19:11, 25 May 2018
- G1 E10 - spit 10 mm of filament
- M503 - prints parameters
- M92 - sets feed rate, such as extruder - M92 E408
- G92 - resets coordinates to given values [1]
- G90 - set absolute positioning
- G91 - set relative positioning
Filament
- M404 N2.85 D1.0 - 2.85 mm filament and nozzle Diameter of 1.0 mm
EEPROM
- M501 Read all parameters from EEPROM.
- M503 Print the current settings – note: NOT the settings stored in EEPROM.
- M501 Read all parameters from EEPROM.
- M502 Reset current settings to defaults, as set in Configurations.h
Notes
- When moving printer in the Cura command line - use G92 without parameters to set all axes to zero
- G1 will always work when coordinates are reset to zero, otherwise if you are alraedy at say E25, G1 E25 will not move the extruder.