G-code: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
=Widely Used= | |||
*G1 E10 - spit 10 mm of filament | *G1 E10 - spit 10 mm of filament | ||
*M503 - prints parameters | *M503 - prints parameters | ||
| Line 12: | Line 13: | ||
*M501 Read all parameters from EEPROM. | *M501 Read all parameters from EEPROM. | ||
*M502 Reset current settings to defaults, as set in Configurations.h | *M502 Reset current settings to defaults, as set in Configurations.h | ||
*M851 Z probe offset from Extruder | |||
=Notes= | =Notes= | ||
Revision as of 21:44, 25 May 2018
Widely Used
- G1 E10 - spit 10 mm of filament
- M503 - prints parameters
- M92 - sets feed rate, such as extruder - M92 E408
- G92 - resets coordinates to given values [1]
- G90 - set absolute positioning
- G91 - set relative positioning
Filament
- M404 N2.85 D1.0 - 2.85 mm filament and nozzle Diameter of 1.0 mm
EEPROM
- M501 Read all parameters from EEPROM.
- M503 Print the current settings – note: NOT the settings stored in EEPROM.
- M501 Read all parameters from EEPROM.
- M502 Reset current settings to defaults, as set in Configurations.h
- M851 Z probe offset from Extruder
Notes
- When moving printer in the Cura command line - use G92 without parameters to set all axes to zero
- G1 will always work when coordinates are reset to zero, otherwise if you are alraedy at say E25, G1 E25 will not move the extruder.
Links
The source - http://reprap.org/wiki/G-code