TMC 2130 Stepper Drivers: Difference between revisions
Jump to navigation
Jump to search
| Line 10: | Line 10: | ||
*Disable endstops_pullup for sensorless homing | *Disable endstops_pullup for sensorless homing | ||
*M914 in sensorless homing determines sensitivity of sensorless homing | *M914 in sensorless homing determines sensitivity of sensorless homing | ||
*Need to upgrade to Marlin 1.1.9 from 1.1.0 to do sensorless homing. | |||
Revision as of 16:46, 14 April 2019
Wire Via SPI for Stealth Mode
- Solder certain bridges on the driver - not easy
- Change Marlin code in configuration_adv.h
- Need to change pins_RAMPS.h file to tell which pins are being used
- Debug allows M122 in serial monitor for status
- Define sensorless_homing in config_adv !!! This is useful.
- Disable endstops_pullup for sensorless homing
- M914 in sensorless homing determines sensitivity of sensorless homing
- Need to upgrade to Marlin 1.1.9 from 1.1.0 to do sensorless homing.