D3D Simple Kit Preparation: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=Product= #Ship extruder wire bundle prepared, terminated, in split wire loom #Ship extruder parts complete, thermistor and heater tested. No tapping required, but full assy r...") |
|||
| Line 9: | Line 9: | ||
#D3D Pro, CNC Torch Table included on SD card or USB stick. | #D3D Pro, CNC Torch Table included on SD card or USB stick. | ||
= | =Kit Preparation Instructions= | ||
==Extruder Wire Bundle== | |||
#Take 6 components | |||
##Probe - remove nuts | |||
##Heater cartridge | |||
##Thermistor | |||
##Motor wire | |||
##Fan | |||
##Blower | |||
#Terminate them | |||
##Put triple plug on probe | |||
##Ferrule the heater ends | |||
##Ferrule the blower | |||
##Ferrule the fan | |||
##(Nothing for thermistor and motor wire | |||
==Extruder== | |||
==Endstops== | |||
==Axes== | |||
==Control Panel== | |||
==Control Panel Wire Kit== | |||
==Base Board== | |||
==Print Bed== | |||
Revision as of 09:16, 9 December 2019
Product
- Ship extruder wire bundle prepared, terminated, in split wire loom
- Ship extruder parts complete, thermistor and heater tested. No tapping required, but full assy required.
- Easy Build Kit - already assembled and tested
- Ship axes with motors with pulleys already on. Customer builds the axes from start to finish. Tape detail on X and Z axes.
- Controller components are pretested for functional LCD. RAMPS assembled but without heat sinks. Motors tested. GFCI wired. Power supply tested. Endstops and probe tested.
- Board precut.
- Bed magnets glued
- D3D Pro, CNC Torch Table included on SD card or USB stick.
Kit Preparation Instructions
Extruder Wire Bundle
- Take 6 components
- Probe - remove nuts
- Heater cartridge
- Thermistor
- Motor wire
- Fan
- Blower
- Terminate them
- Put triple plug on probe
- Ferrule the heater ends
- Ferrule the blower
- Ferrule the fan
- (Nothing for thermistor and motor wire