STag: Difference between revisions
Jump to navigation
Jump to search
(Created Page + Added Basic Sections/Info) |
(Added some more information) |
||
| Line 3: | Line 3: | ||
*May be the best/most stable? | *May be the best/most stable? | ||
* '''Needs a generator program''' | * '''Needs a generator program''' | ||
=Files= | |||
*No unique generator yet, so all are done with the options off of the github...as of now: | |||
==SN:00000== | |||
===Original=== | |||
*[[File: STag SN: 00000.jpeg]] | |||
===Printable Tracked A3 Paper=== | |||
*Use 1 Per Dimention | |||
*Then use the corners as set distances | |||
*Assuming paper is accurate + precise (near gaurentee when flat/glued down), and the printer is (again near guarentee at large enough size) is should be an accurate, repeatable, marker | |||
*Also see if a [[Pen-Holder Toolhead]] can make it | |||
*[[File: STag SN: 00000.jpeg]] | |||
=Internal Links= | =Internal Links= | ||
Revision as of 23:44, 17 May 2020
Basics
- A type of marker for use in 3D Scanning , Motion Capture , and AR/VR/MR
- May be the best/most stable?
- Needs a generator program
Files
- No unique generator yet, so all are done with the options off of the github...as of now:
SN:00000
Original
Printable Tracked A3 Paper
- Use 1 Per Dimention
- Then use the corners as set distances
- Assuming paper is accurate + precise (near gaurentee when flat/glued down), and the printer is (again near guarentee at large enough size) is should be an accurate, repeatable, marker
- Also see if a Pen-Holder Toolhead can make it
- File:STag SN: 00000.jpeg