May Production Plan

Strategy:

• List steps in order of duty – Power Cube to Tractor to CEB press
• Assess capacity required
• Allocate tasks to 6 fabricators and local shop
• List risks and recovery plans
• Assess daily, before and after workday

Shopping List

• Identify Power Beyond Fittings for main valves -

Power Cube Tasks

Shake Down Motor Size

• Start with Power Cube mounting. Measure Power Cube and location of mount
• [2] Cut Mount – 1/4x4 by appropriate measurement
• [2] Drill Mounts – 2 holes on ends each
• Transfer punch mount hole locations for top and bottom mount
• Mark mount hole locations on other side of beams
• Weld Mount eye on bottom of Power Cube
• Weld mount eye on bottom Power Cube Mount
• Mag drill holes in frame -
• Mount Power Cube on Tractor

Build Hydraulic tanks

• Work on 3 at a time
• Grind tanks down to clean
• Clean edges and bungs
• Ream any necessary holes
• Lay out 3 sets on welding table
• Close off bungs with fittings
• Tack everything
• Weld
• Assemble

Prepare Engine and Pump Mounting

• Assess fittings for hydraulic pump
• Put fittings on hydraulic pump
• Cut plate for Engine Mount
• Cut plate for hydraulic pump
• [1] Cut angle for Power Cube Mount

Prepare Hydrauilic system components

• tank

Weld Mufflers – do 8 more

• Secure 8 close nips, 1”
• Secure 8 elbows, 1”
• Cut 2 rings – flange and end piece of large tube
• Grind and ream rings
• Prepare 1 washer – 1/2” - for closing inner tube
• Prepare 1 closure of washer
• Mark pattern for muffler flange
• Torch muffler flange, use #1 torch head
• Procure gasket material for mufflers
• M

“Prepare Second Generator”

• Put fittings on motor
• Pack up old motor