Heat Soak Detection/Quantification: Difference between revisions
Jump to navigation
Jump to search
(Created Page + Added Basic Sections/Info) |
(Added some more information) |
||
| Line 4: | Line 4: | ||
*If an engine is indeed doing a [[Cold Start]] or if it is a “Warm EngineL / near warm could also be qualified and various [[ECU]] parameters adjusted accordingly | *If an engine is indeed doing a [[Cold Start]] or if it is a “Warm EngineL / near warm could also be qualified and various [[ECU]] parameters adjusted accordingly | ||
**If an [[Engine Oil Heater]] / [[Engine Coolant Heater]] / [[Engine Block Heater]] were used as well etc, this would also be a benefit of this sensor system. | **If an [[Engine Oil Heater]] / [[Engine Coolant Heater]] / [[Engine Block Heater]] were used as well etc, this would also be a benefit of this sensor system. | ||
=Potential Forms of Doing This= | |||
==Conventional Route== | |||
*Separate Sensors in Different Spots/Componets | |||
*CAN work, but may introduce complexity in [[Cable Harness]] design, and [[Design for Maintenance]] / [[Design for Component Failure]] | |||
==“Meat Thermometer” / “ [[Dipstick]] “ == | |||
*Essentially have something akin to a [[Meat Thermometer]] / [[Cooking Thermometer]] in function, but the size of an [[Oil Dipstick]] accesible for Maintenance in a similar manner (potentially even in a similar spot) | |||
*All that would be needed would be a cast void, or drilled hole | |||
=Internal Links= | =Internal Links= | ||
Revision as of 14:02, 16 December 2025
Basics
- This page aims to outline the reasons for, and a means of, measuring not only Coolant Temperature or Engine Block Temperature / Exhaust Gas Temperature etc, but the specific temperature at various depths of the Engine Block (Towards the Piston Cylinder Walls), or of various components at different depths or steps in the chain
- The main advantage is one could quantify the Thermal Soak (ie Cold Soak or “Hot Soak” ) of an engine, and measure Heat Creep / Heat Soak
- If an engine is indeed doing a Cold Start or if it is a “Warm EngineL / near warm could also be qualified and various ECU parameters adjusted accordingly
- If an Engine Oil Heater / Engine Coolant Heater / Engine Block Heater were used as well etc, this would also be a benefit of this sensor system.
Potential Forms of Doing This
Conventional Route
- Separate Sensors in Different Spots/Componets
- CAN work, but may introduce complexity in Cable Harness design, and Design for Maintenance / Design for Component Failure
“Meat Thermometer” / “ Dipstick “
- Essentially have something akin to a Meat Thermometer / Cooking Thermometer in function, but the size of an Oil Dipstick accesible for Maintenance in a similar manner (potentially even in a similar spot)
- All that would be needed would be a cast void, or drilled hole