Mount Loader Arm Eyes: Difference between revisions
Jump to navigation
Jump to search
(Created page with " '''Build QA Plate Mounting Eyes'''") |
No edit summary |
||
| Line 1: | Line 1: | ||
*Cut [2] 3x7x1" pieces with bandsaw | |||
*Weld pieces together | |||
*Drill pieces for eye hole | |||
*Torch out slit | |||
*Cut piece of 1" rebar for inside of arms, reinforcement | |||
*Insert 1" shaft through both eyes of tractor arms | |||
*Weld eyes in place | |||
[[Category:Fabrication Procedures]] | |||
Revision as of 03:24, 19 June 2011
- Cut [2] 3x7x1" pieces with bandsaw
- Weld pieces together
- Drill pieces for eye hole
- Torch out slit
- Cut piece of 1" rebar for inside of arms, reinforcement
- Insert 1" shaft through both eyes of tractor arms
- Weld eyes in place