CEB Press/Manufacturing Instructions/Valve Mount: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
No edit summary
Line 1: Line 1:
{{Category=CEB press building instructions}}
{{Category=CEB press building instructions}}
{{Template:CEB Press Manufacturing Instructions Navbox}}
 
The valve mount holds the hydraulic solenoid valves to the primary arm.
The valve mount holds the hydraulic solenoid valves to the primary arm.
<html><iframe src="http://sketchup.google.com/3dwarehouse/mini?mid=a239d963ea082d1a1211da1f85706ccd&etyp=im&width=400&height=300" frameborder="0" scrolling="no" marginheight="0" marginwidth="0" width="400" height="300"></iframe></html>
 
=Tools required=
=Tools=
 
*Hole puncher with 13/16" Dies
*Hole puncher with 13/16" Dies
*Drill Press with 1/4" or larger bit.
=Materials required=
*1/4"x6" flatbar: 12"
*Solenoid Valve


=Diagrams=
*Drill Press with 5/16" or larger bit.
[[Image:valvemount.png|thumb|600px|The valve mount]]
 
=Fabrication instructions=
=Materials=  
#Find your hydraulic solenoid valve and locate its mounting holes on the back. Put the plate under it so that the mounts on the valve align with the top of the plate.  
 
#Use spray paint to mark the holes on the mount's location to the 6"x12" plate. Center punch them.
*Steel plate 1/4" x 6" x 12"
#Drill the holes to at least a 1/4" large (you might want to oversize them a bit, as it very difficult to get them in the perfect location.)
 
#Punch 13/16" holes at the bottom of the plate.
*Solenoid Valve Set
 
=Steps=
 
*Set the steel plate on a flat surface
 
*Position the solenoid valve set over the plate such that its work port surface is flush with the top edge and square with the side edges of the steel plate.  
 
*Using the marking utensil and the center punch, mark then center punch the 4 aligned holes at the sides of the steel plate
 
*Drill 4 holes of 5/16" diameter at the marked points of the steel plate
 
*Punch 2 holes of 13/16" diameter that are centered 20cm from each other and 3cm from the bottom edge of the steel plate.

Revision as of 23:54, 22 December 2011

Main > Housing and construction > CEB Press > CEB press building instructions

The valve mount holds the hydraulic solenoid valves to the primary arm.

Tools

  • Hole puncher with 13/16" Dies
  • Drill Press with 5/16" or larger bit.

Materials

  • Steel plate 1/4" x 6" x 12"
  • Solenoid Valve Set

Steps

  • Set the steel plate on a flat surface
  • Position the solenoid valve set over the plate such that its work port surface is flush with the top edge and square with the side edges of the steel plate.
  • Using the marking utensil and the center punch, mark then center punch the 4 aligned holes at the sides of the steel plate
  • Drill 4 holes of 5/16" diameter at the marked points of the steel plate
  • Punch 2 holes of 13/16" diameter that are centered 20cm from each other and 3cm from the bottom edge of the steel plate.
Retrieved from "https://wiki.opensourceecology.org/index.php?title=CEB_Press/Manufacturing_Instructions/Valve_Mount&oldid=49122"