Cold Saw/Understand4: Difference between revisions
< Cold Saw
Jump to navigation
Jump to search
(→Vise) |
|||
| Line 14: | Line 14: | ||
[http://opensourceecology.org/wiki/Cold_Saw/Depth_Blade_Slot Depth of Blade Slot] | [http://opensourceecology.org/wiki/Cold_Saw/Depth_Blade_Slot Depth of Blade Slot] | ||
[http://opensourceecology.org/wiki/Cold_Saw/Maximum_Cut_Height Maximum Cut Height] | |||
=Dimensions= | =Dimensions= | ||
Revision as of 19:21, 26 June 2012
Vise
The vise holds the material to be cut.
The vise should be auto-centering such that the vise can accommodate angled cuts more effectively and facilitate the blade descent at the middle of the material width.
For a given cut width, the maximum cut height is determined by the diameter of the blade and the blade supports.
Diagram
Calculations
Dimensions
The mounting holes for the vise are 12mm diameter to fit the M12x1.75 screws used uniformly.
The vise shafts are 31.8mm diameter, the same diameter as in the rotation assembly.
The vise threaded rod is M30x3.5 to fit within 32mm diameter holes uniformly used for the vise shafts.
Depth of the blade slot is 25.4mm (20mm required for 350mm diameter blade, 115mm material width, and up to 45 degree cuts)