Ironworker/Manufacturing Instructions: Difference between revisions
Jump to navigation
Jump to search
(Created page with 'See Ironworkers for introduction. We start the build of the ''open source ironworker'' with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based …') |
No edit summary |
||
| Line 6: | Line 6: | ||
[[Image:holepuncher.jpeg]] | [[Image:holepuncher.jpeg]] | ||
You can download the file [http://openpario.mime.oregonstate.edu:3000/documents/96 here.] | |||
[[Category:Ironworker]][[Category:Hole Puncher]][[Category:RepLab]] | [[Category:Ironworker]][[Category:Hole Puncher]][[Category:RepLab]] | ||
Revision as of 07:41, 10 February 2010
See Ironworkers for introduction.
We start the build of the open source ironworker with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate.
Initial CAD, not finished:
You can download the file here.