Ironworker/Manufacturing Instructions: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
=Introduction= | |||
See [[Ironworkers]] for introduction. | See [[Ironworkers]] for introduction. | ||
=Build= | |||
We start the build of the ''open source ironworker'' with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate. | We start the build of the ''open source ironworker'' with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate. | ||
| Line 8: | Line 11: | ||
You can download the file [http://openpario.mime.oregonstate.edu:3000/documents/96 here.] | You can download the file [http://openpario.mime.oregonstate.edu:3000/documents/96 here.] | ||
=Design v0.1= | |||
[[Image:holepuncher01.jpg]] | |||
[[Category:Ironworker]][[Category:Hole Puncher]][[Category:RepLab]] | [[Category:Ironworker]][[Category:Hole Puncher]][[Category:RepLab]] | ||
Revision as of 03:27, 26 June 2010
Introduction
See Ironworkers for introduction.
Build
We start the build of the open source ironworker with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate.
Initial CAD, not finished:
You can download the file here.
Design v0.1
