How to Make Arduino Cables: Difference between revisions
Jump to navigation
Jump to search
| Line 18: | Line 18: | ||
*About JST connectors - these are connectors for Nema 17 Steppers, for example. | *About JST connectors - these are connectors for Nema 17 Steppers, for example. | ||
<html><iframe width="560" height="315" src="https://www.youtube.com/embed/wn3ixZ-sv5w" frameborder="0" allowfullscreen></iframe></html> | <html><iframe width="560" height="315" src="https://www.youtube.com/embed/wn3ixZ-sv5w" frameborder="0" allowfullscreen></iframe></html> | ||
*Regarding JST - we'd like to know how to make the actual wire + connector | |||
Latest revision as of 18:34, 12 May 2017
Ready Made
These are Dupont Connectors
From Source
- Insulation Displacement Connectors (IDC or IPC) [1] use piercing of insulation for the terminal. Here is an example of the cable - [2]
- Dupont connectors - with M/F housings + pin headers - [3]
- Crimping tool can put both male and female pins into the housing:
Stepper Motor Connectors
- How to figure out windings -
- JST PHR-6 connectors - typical for Nema 17 motors - [4]
- About JST connectors - these are connectors for Nema 17 Steppers, for example.
- Regarding JST - we'd like to know how to make the actual wire + connector