Marlin Settings for Geared Extruders: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 16: | Line 16: | ||
< echo:Maximum Acceleration (mm/s2): | < echo:Maximum Acceleration (mm/s2): | ||
< echo: M201 X3000 Y3000 Z100 E10000 | < echo: M201 X3000 Y3000 Z100 E10000 | ||
*Note that max feedrate on Z is problematic - E25.00. Set that to 200 | |||
=Links= | =Links= | ||
*Extruder Settings instructions from E3D - [https://e3d-online.dozuki.com/Guide/Titan+Aero+Marlin+Configuration/39] | *Extruder Settings instructions from E3D - [https://e3d-online.dozuki.com/Guide/Titan+Aero+Marlin+Configuration/39] | ||
Revision as of 21:15, 25 April 2018
Marlin is Acting Up
This [1] shows how to set up Marlin for a geared Titan Aero extruder. Setting the Axis steps was done - yet extrusion happens now at a very slow rate, almost invisible. Testing extrusion in Cura works as it should - only to fail upon running a print. What gives??
- Could config.ino be overriding steps per mm?
- Hint - do M92 E837 in the start gcode? Save with M500
- Note that currently EEPROM is on in Configuration.h
- Note that listing EEPROM settings with M501 -
> M501 < echo:Hardcoded Default Settings Loaded < echo:Steps per unit: < echo: M92 X80.00 Y80.00 Z80.00 E837.00 < echo:Maximum feedrates (mm/s): < echo: M203 X300.00 Y300.00 Z10.00 E25.00 < echo:Maximum Acceleration (mm/s2): < echo: M201 X3000 Y3000 Z100 E10000
- Note that max feedrate on Z is problematic - E25.00. Set that to 200
Links
- Extruder Settings instructions from E3D - [2]