D3D v18.04 Software: Difference between revisions
Jump to navigation
Jump to search
(→Notes) |
|||
| Line 8: | Line 8: | ||
=Notes= | =Notes= | ||
#Machine settings currently on OSE Linux v1.0 - [[File:d3dsettings.jpg]] | #Machine settings currently on OSE Linux v1.0 - [[File:d3dsettings.jpg|300px]] | ||
=To Get Proper Prints with a New Extruder= | =To Get Proper Prints with a New Extruder= | ||
Revision as of 22:19, 24 May 2018
Background
There are 6 places where software may be configured when developing new versions of the OSE 3D Printer:
- Marlin - versions after April 23, 2018 work - File:OSE Marlin.zip
- Configuration file (.ini) in Cura.
- Start and end g-codes in Cura - contained in configuration file
- Machine Settings in Cura - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament.
- Print parameters in Cura - contained in configuration file
Notes
- Machine settings currently on OSE Linux v1.0 -
To Get Proper Prints with a New Extruder
- Verify e-steps for the extruder - and make sure Cura machine settings are consistent.
- Test extruder - so it's extruding correctly with Cura interface
Software
Marlin
- D3D v18.04 Marlin is updated for a geared extruder - see - File:OSE Marlin.zip