Revision as of 19:48, 6 June 2018

Note that LCD controller and Cura agree on motion direction. + and - of each axis works equally well in the LCD and in OSE Lulzbot Cura. LCD control is relative from the 0 point.
Note that if cables are crossed, some steppers work with crossed cables (where order of certain pairs is reversed) - while other steppers do not. This indicates that the internal wiring of the steppers differs between steppers.

Homing

X and Y home well
Z moves down and stops. Huh? Never seen this before. Z stop triggered without z probe connected?

< Reporting endstop status < x_min: open < y_max: open < z_min: TRIGGERED

Issue - Z probe - I have LJ18A3-8-Z/BY-5V. Is BX recommended? What is the difference? [1]. See Instructables article.

@@ Line 9: / Line 9: @@
 < y_max: open
 < z_min: TRIGGERED
-*Issue - Z probe - I have LJ18A3-8-Z/BY-5V. Is BX recommended? What is the difference? [https://www.ebay.com/itm/LJ18A3-8-Z-BX-DC-6-36V-NPN-3-wire-8mm-Inductive-Proximity-Sensor-Switch-Detector-/271664656457?hash=item3f4079b049]
+*Issue - Z probe - I have LJ18A3-8-Z/BY-5V. Is BX recommended? What is the difference? [https://www.ebay.com/itm/LJ18A3-8-Z-BX-DC-6-36V-NPN-3-wire-8mm-Inductive-Proximity-Sensor-Switch-Detector-/271664656457?hash=item3f4079b049]. See [http://www.instructables.com/id/Enable-Auto-Leveling-for-your-3D-Printer-Marlin-Fi/ Instructables article].