Angle Frame Connector: Difference between revisions
Jump to navigation
Jump to search
| Line 16: | Line 16: | ||
=Production= | =Production= | ||
*50% infill | |||
*10 cm cut off the bottom, standing on corner - . This would not stand on moving-bed printers. Babystepping correction -0.75. It does not stand on a stationary bed printer eiether. I turned it around to print standing on 6 points. | *10 cm cut off the bottom, standing on corner - . This would not stand on moving-bed printers. Babystepping correction -0.75. It does not stand on a stationary bed printer eiether. I turned it around to print standing on 6 points. | ||
[[File:angleconnectorstl.png|500px]] | [[File:angleconnectorstl.png|500px]] | ||
Revision as of 20:33, 7 October 2019
CAD
Angle Connector. - FreeCAD with McMaster 6 mm nut -File:Angleconnector.fcstd. Finished STL - File:Anglecorner.stl
Concept
Production
- 50% infill
- 10 cm cut off the bottom, standing on corner - . This would not stand on moving-bed printers. Babystepping correction -0.75. It does not stand on a stationary bed printer eiether. I turned it around to print standing on 6 points.
- Came off bed so printed it on 6 corners:
- Initial fit: metal shown with 6 mm hex nut and set screw in the hole.
- STL - sunk 5 mm into bed.
