D3D Simple Kit Preparation

Product

1. Ship extruder wire bundle prepared, terminated, in split wire loom
2. Ship extruder parts complete, thermistor and heater tested. No tapping required, but full assy required.
   1. Easy Build Kit - already assembled and tested
3. Ship axes with motors with pulleys already on. Customer builds the axes from start to finish. Tape detail on X and Z axes.
4. Controller components are pretested for functional LCD. RAMPS assembled but without heat sinks. Motors tested. GFCI wired. Power supply tested. Endstops and probe tested.
5. Board precut.
6. Bed magnets glued
7. D3D Pro, CNC Torch Table included on SD card or USB stick.

Kit Preparation Instructions

Extruder Wire Bundle

1. Take 6 components
   1. Probe - remove nuts
   2. Heater cartridge
   3. Thermistor
   4. Motor wire
   5. Fan
   6. Blower
2. Terminate them
   1. Put triple plug on probe
   2. Ferrule the heater ends
   3. Ferrule the blower
   4. Ferrule the fan
   5. (Nothing for thermistor and motor wire

Endstops

1. Take 2 standard endstop wires.
2. Take or trim 2 endstops
3. Repin for position 1&2 with green and red wire, cut off black wire. Green goes to lever base side.
4. Solder connections, heat shrink
5. Mount in endstop holder facing right.

Printed Parts

Collect and bag printed parts:

1. Control panel
2. Extruder main
3. Extruder second side
4. Extruder lever
5. 2 Z base
6. 5 Carriage
7. ZX Connector
8. 5 Idler
9. 1 raised motor
10. 1 raised idler
11. 2 motor pieces
12. 6 pegs
13. 2 endstops

Build Instructions

1. Build axes
2. Mount extruder
3. Assemble controller with its internal wirring
4. Assemble heat bed
5. Screw down parts, using printed paper template
6. Fix wires, plug components in
7. Mount the spool holder
8. Print!

Production Ergonomics for 12 kits

1. Axis parts bagging, 1 hour after printing
2. Controller parts testing, 1 hr
3. Board cutting - 30 minutes
4. Extruder prep - make heatsinks- 1 hour
   1. Take 21" of stock, put jig on it to drill-mark with 3 mm bit
   2. Take off jig and drill through
   3. Tap 12 holes
   4. Cut blocks
5. File corners with disc sander (use grinder with flapper wheel)

1. 1. Tap

1. Extruder