Backlash: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
*Gears compared with HTD 5 mm pitch 15 mm wide 24T pulleys [https://www.chiefdelphi.com/t/belts-vs-gears/159650/10] | *Gears compared with HTD 5 mm pitch 15 mm wide 24T pulleys [https://www.chiefdelphi.com/t/belts-vs-gears/159650/10] | ||
*Belts may appear cheaper than chain but maintenance cost is higher [https://www.quora.com/Why-would-you-use-a-belt-drive-instead-of-a-chain-drive] | *Belts may appear cheaper than chain but maintenance cost is higher [https://www.quora.com/Why-would-you-use-a-belt-drive-instead-of-a-chain-drive] | ||
*'''Excellwnt thread on stretch data for steel vs nylon belted belts.''' Kevlar is similar to steel. Stretch is about 0.2% per 20lb of force. [https://community.carbide3d.com/t/belt-stretch-and-stepper-holding-measured/18480/106] | *'''Excellwnt thread on stretch data for steel vs nylon belted belts.''' Kevlar is similar to steel. Stretch is about 0.2% per 20lb of force. [https://community.carbide3d.com/t/belt-stretch-and-stepper-holding-measured/18480/106]. Steel has 2x stretch. | ||