D3D Pro v23.12 Troubleshooting and Repair: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
No edit summary
No edit summary
Line 1: Line 1:
{{RightTOC}}
=Print & Maintenance Log=
=Print & Maintenance Log=
<nowiki>{{log|date=|time=|note=}}</nowiki>
<nowiki>{{log|date=|time=|note=}}</nowiki>
Line 17: Line 18:


{{log|date=2024/06/24|time=10:24pm|note=Ringing tower test print - Cancelled - Print speeds not high enough - Polymaker PLA Black}}
{{log|date=2024/06/24|time=10:24pm|note=Ringing tower test print - Cancelled - Print speeds not high enough - Polymaker PLA Black}}
{{RightTOC}}

Revision as of 12:03, 6 July 2024

Print & Maintenance Log

{{log|date=|time=|note=}}


2024/06/24 | 11:49pm

  • Bj. S. P. 2 - Failed - nozzle too close to bed - filament stripped. I forgot to save the previous bed offset; live adjusted Z to compensate and attempt recovery. X axis belt clamp is too low - damaging prints. Failure - Bed adhesion, underextrusion, filament stripping.


2024/06/24 | 11:46pm

  • Blackjack Shoe Plate 2 - probing failed, bed misaligned


2024/06/24 | 11:43pm

  • Failure to heat bed - M112 error


2024/06/24 | 11:38pm

  • R.T.T.P. - turned off linear advance @ ~10% - Print looking okay at 60% - some underextrusion early on. Print successful! Horizontal artiface appears in a repeating pattern every 7mm. (Primarily cosmetic issue). Printed this model in incorrect orientation


2024/06/24 | 11:11pm

  • R.T.T.P. - Paused @ skirt for stripped filament. Failed @ 5-10%. Stripped filament


2024/06/24 | 11:08pm

  • R.T.T.P. - Speed too high? Seemingly exceeding max volumetric flow rate. Failed - underextrusion


2024/06/24 | 10:45pm

  • Ringing tower test print - Cancelled - Forgot to adjust min. layer time


2024/06/24 | 10:24pm

  • Ringing tower test print - Cancelled - Print speeds not high enough - Polymaker PLA Black
Retrieved from "https://wiki.opensourceecology.org/index.php?title=D3D_Pro_v23.12_Troubleshooting_and_Repair&oldid=298291"