Build Hydraulic Tanks: Difference between revisions
Jump to navigation
Jump to search
(Created page with "*Cut 1/4"x6"x12" tube for hydraulic tank *Secure 3 bungs - 3/4" for filler/breather, 1" for return line filter, and 2" for suction strainer (extender plus bunk *Grind tanks down...") |
No edit summary |
||
| Line 1: | Line 1: | ||
*Cut 1/4"x6"x12" tube for hydraulic tank | *[1] Cut 1/4"x6"x12" tube for hydraulic tank | ||
*Secure 3 bungs - 3/4" for filler/breather, 1" for return line filter, and 2" for suction strainer (extender plus | *[2] Cut 1/4"x6"x12" end closures | ||
*Secure 3 bungs - 3/4" for filler/breather, 1" for return line filter, and 2" for suction strainer (extender plus bung proper) | |||
*Grind | *Torch out 3 bung holes as in last step | ||
*Grind tank edges and bung edges clean wherever bead will be welded. | |||
*Clean edges and bungs | *Clean edges and bungs | ||
*Ream any necessary holes | *Ream any necessary holes | ||
| Line 11: | Line 12: | ||
*Assemble tank | *Assemble tank | ||
*Test hydraulic tank with air pressure and soap solution | *Test hydraulic tank with air pressure and soap solution | ||
[[Category:Fabrication Procedures]] | |||
Revision as of 21:55, 18 June 2011
- [1] Cut 1/4"x6"x12" tube for hydraulic tank
- [2] Cut 1/4"x6"x12" end closures
- Secure 3 bungs - 3/4" for filler/breather, 1" for return line filter, and 2" for suction strainer (extender plus bung proper)
- Torch out 3 bung holes as in last step
- Grind tank edges and bung edges clean wherever bead will be welded.
- Clean edges and bungs
- Ream any necessary holes
- Lay out 3 sets on welding table
- Close off bungs with fittings
- Tack everything
- Weld
- Assemble tank
- Test hydraulic tank with air pressure and soap solution