Main Cylinder Top/2nd Cyl Bottom Mounts: Difference between revisions
Jump to navigation
Jump to search
(Created page with "*Cut 6x12x1/2" plate *Drill 4 holes on 2 pin holes on each plate *Weld 1" drilled out nut onto plates *Bolt to arms Category:Fabrication Procedures") |
No edit summary |
||
| Line 1: | Line 1: | ||
*Cut | *Cut 1/2"X6"x12" plate | ||
* | *Cut 1/2"x4"x6" plate | ||
*Weld 1" drilled out nut onto plates | *Mag drill [4] 3/4" holes in 6"x12: plate | ||
* | *Mag drill [2] 1" pin holes on each 4"x6" plate | ||
*Weld 1" drilled out nut onto 4"x6" plates | |||
*Weld assembly together with cylinder pin in place (prevents shifting) | |||
*Lay assembly in place on frame, and pin bottom of main cylinder into it | |||
[[Category:Fabrication Procedures]] | [[Category:Fabrication Procedures]] | ||
Revision as of 01:28, 19 June 2011
- Cut 1/2"X6"x12" plate
- Cut 1/2"x4"x6" plate
- Mag drill [4] 3/4" holes in 6"x12: plate
- Mag drill [2] 1" pin holes on each 4"x6" plate
- Weld 1" drilled out nut onto 4"x6" plates
- Weld assembly together with cylinder pin in place (prevents shifting)
- Lay assembly in place on frame, and pin bottom of main cylinder into it