Shonda Log: Difference between revisions
(→aug 22) |
No edit summary |
||
| Line 1: | Line 1: | ||
==aug 23== | |||
wood gasifier open source kit [[http://gekgasifier.com/]] | |||
horizontal milling machine in previous post not going to work machine is built for facing pieces not tool room work the z axis has about 2 1/2in of travel rather then 12 or more inches that would be useful, also most of the controls are hydraulic with dogs rather then hand cranks. | |||
==aug 22== | ==aug 22== | ||
internet was out in the morining, it apears that mice use the power switch as a foot hold for getting to the ceiling | internet was out in the morining, it apears that mice use the power switch as a foot hold for getting to the ceiling | ||
| Line 14: | Line 22: | ||
put up eves on shed roof with adam | put up eves on shed roof with adam | ||
found this http://www.ebay.com/itm/Cincinnati-Model-1-18-Production-Milling-Machine-1940s-/380340594021?pt=BI_Mills&hash=item588e10e565#shId | found this horizontal milling machine [[http://www.ebay.com/itm/Cincinnati-Model-1-18-Production-Milling-Machine-1940s-/380340594021?pt=BI_Mills&hash=item588e10e565#shId]] | ||
picture from Adam and Tom | |||
put up roofing with Marcin and Briana until 3:30 AM | |||
==aug 21== | ==aug 21== | ||
Revision as of 19:51, 23 August 2011
aug 23
wood gasifier open source kit [[1]]
horizontal milling machine in previous post not going to work machine is built for facing pieces not tool room work the z axis has about 2 1/2in of travel rather then 12 or more inches that would be useful, also most of the controls are hydraulic with dogs rather then hand cranks.
aug 22
internet was out in the morining, it apears that mice use the power switch as a foot hold for getting to the ceiling
revived message from multimachine group (log in Multimachine/Research Development)
worked on lathe motor mounting plate holes were offset. still need to weld 4by4 pipe and motor quick attach plate on. possible difficulty, coupler for motor and 1 7/8 shaft.
helped adam with box blading new workshops site. boxblade quick attach plate started breaking apart and we had to torch bolts off since they were bent then weld a new plate with smaller hole so that the blade wont rip out of the quick attach holder.
spent a 3 hours box blading the site then the second bolt plate ripped out and we brought the tractor back.
my power cord for my computer should be at the post office as of this morning
put up eves on shed roof with adam
found this horizontal milling machine [[2]]
picture from Adam and Tom
put up roofing with Marcin and Briana until 3:30 AM
aug 21
researched concrete machine tools - result - multimachine group is closer then I origenaly thought to releasing designs for a lathe design
helped Adam unstick tractor from second entry way and then moved wood from the chestnut tree to chip pile and wood pile. put up one level line for the workshop.