Latest revision as of 22:54, 15 June 2012

Swivel Plate

Length: 406.4mm (Long enough to support the drive assembly such that the blade is centered on the vise)

Width: 203.2mm (Wide enough to fit the shaft blocks wide enough to support the drive assembly such that the blade is centered on the vise)

@@ Line 1: / Line 1: @@
 =Swivel Plate=
-*'''Length: 457.2mm''' (Long enough to support the drive assembly such that the blade is centered on the vise)
+*'''Length: 406.4mm''' (Long enough to support the drive assembly such that the blade is centered on the vise)
 *'''Width: 203.2mm''' (Wide enough to fit the shaft blocks wide enough to support the drive assembly such that the blade is centered on the vise)
 *'''Thickness: 25.4mm'''
 *'''Swivel Hole Diameter: 30mm'''
-*'''Swivel Hole Along Length; 400mm from Edge'''
+*'''Swivel Hole Along Length; Near Edge'''
 *'''Swivel Hole Spacing Along Width: Centered'''
-*'''Support Hole Diameter: 12mm with 20mm dia 13 deep countersink'''
-*'''Support Hole Rectangle: 30mm x 55mm'''
-*'''Support Hole Rectangle Positioning: Centered, 140mm apart center to center.'''
-*'''Support Hole Notes: The Support holes must be positioned such that the blade is centered at the vise. The blade should be centered at the vise so that angled cuts are facilitated in both directions (angling to both left and right). The Support holes should also leave enough space between the Shaft Blocks such that a thrust washer and clamping shaft collar can fit in between (and be easily maintained).'''