Cold Saw/Build Instructions/Swivel: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=Swivel Plate= Clamp the Swivel Plate onto the table. Measure, mark, pilot drill, and drill the swivel hole. =Shaft Blocks= Clamp two Shaft Blocks onto the table, one on top ...") |
No edit summary |
||
| Line 14: | Line 14: | ||
Measure, mark, drill, counterbore, and tap the stopper hole. | Measure, mark, drill, counterbore, and tap the stopper hole. | ||
=Shaft Blocks to Swivel Plate= | |||
Clamp the Shaft Blocks to the Swivel Plate's rear, such that their outer faces along the shaft axis are less than 130mm and also that the shaft blocks are approximately parallel to the Swivel Plate's faces. | |||
Insert the Shaft into the Shaft Blocks for alignment. | |||
Tack weld and weld the Shaft Blocks to the Swivel Plate. | |||
Revision as of 20:42, 19 June 2012
Swivel Plate
Clamp the Swivel Plate onto the table.
Measure, mark, pilot drill, and drill the swivel hole.
Shaft Blocks
Clamp two Shaft Blocks onto the table, one on top of the other and oriented to drill the shaft hole.
Measure, mark, pilot drill, and drill the shaft hole, match drilling into the shaft block underneath.
Clamp a Shaft Block, oriented to drill the stopper hole.
Measure, mark, drill, counterbore, and tap the stopper hole.
Shaft Blocks to Swivel Plate
Clamp the Shaft Blocks to the Swivel Plate's rear, such that their outer faces along the shaft axis are less than 130mm and also that the shaft blocks are approximately parallel to the Swivel Plate's faces.
Insert the Shaft into the Shaft Blocks for alignment.
Tack weld and weld the Shaft Blocks to the Swivel Plate.