Cold Saw/Understand4: Difference between revisions
< Cold Saw
Jump to navigation
Jump to search
(→Vise) |
(→Parts) |
||
| Line 16: | Line 16: | ||
=Parts= | =Parts= | ||
[http://opensourceecology.org/wiki/Cold_Saw/V1_Design_Files/Fixed_Block Fixed Block] | |||
[http://opensourceecology.org/wiki/Cold_Saw/V1_Design_Files/Moving_Block Moving Block] | |||
[http://opensourceecology.org/wiki/Cold_Saw/V1_Design_Files/Clamp_Block Clamp Block] | |||
[http://opensourceecology.org/wiki/Cold_Saw/V1_Design_Files/Vise_Jaw Vise Jaw] | |||
=Fasteners= | |||
=Shaft Accessories= | |||
=Next= | =Next= | ||
Revision as of 22:28, 25 June 2012
Vise
The vise holds the material to be cut.
The vise should be auto-centering such that the vise can accommodate angled cuts more effectively and facilitate the blade descent at the middle of the material width.
Diagram
Dimensions
The mounting holes for the vise are 12mm diameter to fit the M12x1.75 screws used uniformly.
The vise shafts are 31.8mm diameter, the same diameter as in the rotation assembly.
The vise threaded rod is M30x3.5 to fit within 32mm diameter holes uniformly used for the vise shafts.