Cold Saw/Understand4: Difference between revisions
< Cold Saw
Jump to navigation
Jump to search
(→Parts) |
|||
| Line 54: | Line 54: | ||
[http://opensourceecology.org/wiki/Cold_Saw/V1_Design_Files/Medium_Shaft_Collar Medium Shaft Collar] | [http://opensourceecology.org/wiki/Cold_Saw/V1_Design_Files/Medium_Shaft_Collar Medium Shaft Collar] | ||
[http://opensourceecology.org/wiki/Cold_Saw/V1_Design_Files/Handle_Collar Handle Collar] | |||
=Next= | =Next= | ||
Revision as of 00:46, 26 June 2012
Vise
The vise holds the material to be cut.
The vise should be auto-centering such that the vise can accommodate angled cuts more effectively and facilitate the blade descent at the middle of the material width.
Diagram
Calculations
Dimensions
The mounting holes for the vise are 12mm diameter to fit the M12x1.75 screws used uniformly.
The vise shafts are 31.8mm diameter, the same diameter as in the rotation assembly.
The vise threaded rod is M30x3.5 to fit within 32mm diameter holes uniformly used for the vise shafts.
Depth of the blade slot is 25.4mm (20mm required for 350mm diameter blade, 115mm material width, and up to 45 degree cuts)