Negligiblek's Pyrolysis Empirical Model

Model for Empirical Knowledge

I have zero experience with pyrolysis. Since Marcin asked me to lead this project, I realized I'd need to know what I was talking about when I attempted to lure and retain more experienced Pyrolysis Collaborators.

I did not study anything or look at many designs before I began. I simply wanted to build a model and see what issues arise which others have experienced but don't really list in their experimental findings. Nor did I do any calculations of any sort. I winged it. If it blows up on me, I'll do more homework (call me Sir Francis as in Bacon: hopefully not burnt bacon).

Unscaled Drawing of Model

The overall conceptual goal is to get oil out of the cooling coils on the right side after inserting a biomass where the elliptical shape is in the pipe, sealing the pipe with teflon tape and a threaded cap, and heating the pipe directly under the biomass with MAPP gas for an undetermined amount of time.

The loop on the left side is a crude attempt at trying to trap soot for further burning by inclining the model 20 degrees on the left side. Should the gases ever reach laminar flow, convection along with laminar flow fluid dymanics: AV=AV (where A=cross sectional area the flow passes through, and V=the velocity of the fluid), may cause circulation in the loop.

If soot and cinder stay mostly to the left, then the outlet for the gases and the water in the water basin should stay cleaner.

The pressure inside the combustion chamber should be equal to the height of the column of water the outlet pipe is submerged under (15cm).

Density of tap water at 20 deg C: .99823 g/cm3 or 998.23kg/m3 Pressure=density*g*h= (998.23kg/m3)*(9.81m/s2)*.15m = 1468.895445 Pa (kg/m*s2) or about 0.213 psi over and above atmospheric pressure.

Photos of Manufacture and Assembly

Partial Collection of Parts March 21st, 2009

Missing from the parts above are:

• 1' 2" dia copper pipe length;
• 2" Cap, 2" Screw Cap;
• Unknown copper pipe length for feed back loop
• Water basin
• Water basin lid
• Water basin lid gasket

Not shown in pictures is the MAPP gas canister and torch head.

• The two right most vertical pipes will go through the water basin lid.
• The right most vertical pipe will be inside the water basin but not submerged in water and will have 10' of 1/2" copper tubing on the top end.
• The other end of the 1/2" copper tubing will terminate in the 1/4 turn shut off valve.
• On the far left side of the picture, one vertical pipe is missing; hence the hanging elbow.
• The next two left most (and present) vertical parts will connect into the missing 1' x 2" dia. copper pipe

March 29th, 2009 Obtained the following parts:

• 36" of 2" dia copper pipe
• Two 2" to 3/4" tees
• 2" to 1.5" coupler
• 1.5" to 1/2" coupler
• 5' of 1/2" copper pipe
• 1/2" to 3/4" coupler
• 2" copper threaded end
• steel cap
• teflon tape

Obviously, these are not the parts I had intended. Being in a hurry, I made do with what the hardware store had in supply.

March 29th, 2009 Assembled All parts with the exception of:

• water basin
• water basin lid
• Did not solder cooling tube to outlet
• Did not crimp 1/4 turn valve on to cooling tube

No, the soldering doesn't look pretty and I didn't try to clean it up before I shot it either. It does hold air though. The hunt for a good water basin continues.

April 3rd, 2009 Obtained Water Basin, and Modeling clay to seal Water Basin