Everlast PowerPro 256: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 7: | Line 7: | ||
*[http://www.everlastgenerators.com/welding-calculators.php Everlast - Welding Setup Calculator] | *[http://www.everlastgenerators.com/welding-calculators.php Everlast - Welding Setup Calculator] | ||
*[http://www.everlastgenerators.com/downloads/PowerPro-and-PowerUltra.pdf Manual] | *[http://www.everlastgenerators.com/downloads/PowerPro-and-PowerUltra.pdf Manual] | ||
===Plasma Cutter Settings=== | |||
*cut mode | |||
*poles set at dc | |||
*turn all green knobs to left except for the post flow | |||
*pulse off | |||
*2t mode | |||
*main amperage control - 50 or 60 | |||
*if we have the amperage control to 60 = we'll be drawing 50 amps | |||
*ground clamp as close to the metal as possible | |||
*maintain about 70 to 75 psi on the air compressor | |||
*4 cf/ minute on the air compressor | |||
Latest revision as of 21:11, 17 October 2012
Overview
Use
Settings
Plasma Cutter Settings
- cut mode
- poles set at dc
- turn all green knobs to left except for the post flow
- pulse off
- 2t mode
- main amperage control - 50 or 60
- if we have the amperage control to 60 = we'll be drawing 50 amps
- ground clamp as close to the metal as possible
- maintain about 70 to 75 psi on the air compressor
- 4 cf/ minute on the air compressor
Plasma Cutting Tutorial
TIG Tutorial Videos
Not the same machine, but its setup the same way
Also: