Marlin Settings for Geared Extruders

From Open Source Ecology
Revision as of 21:02, 25 April 2018 by Marcin (talk | contribs)
Jump to navigation Jump to search

Marlin is Acting Up

This [1] shows how to set up Marlin for a geared Titan Aero extruder. Setting the Axis steps was done - yet extrusion happens now at a very slow rate, almost invisible. Testing extrusion in Cura works as it should - only to fail upon running a print. What gives??

  • Could config.ino be overriding steps per mm?
Retrieved from "https://wiki.opensourceecology.org/index.php?title=Marlin_Settings_for_Geared_Extruders&oldid=170548"