G-code

• G1 E10 - spit 10 mm of filament
• M503 - prints parameters
• M92 - sets feed rate, such as extruder - M92 E408
• G92 - resets coordinates to given values [1]
• G90 - set absolute positioning
• G91 - set relative positioning

EEPROM

• M501 Read all parameters from EEPROM.
• M503 Print the current settings – note: NOT the settings stored in EEPROM.
• M501 Read all parameters from EEPROM.
• M502 Reset current settings to defaults, as set in Configurations.h

Notes

• When moving printer in the Cura command line - use G92 without parameters to set all axes to zero
• G1 will always work when coordinates are reset to zero, otherwise if you are alraedy at say E25, G1 E25 will not move the extruder.