120V Heatbed

About

• OSE Reasons for using it are scalability and low cost for large beds. For small beds, we can make whatever size we need.
• Hackaday article - [1]

Sourcing

Pad

• Expensive on amazon - [2]
• Silicone rubber sheet - to 450F - [3] - $6/sf
• 10x10" heatbed aliexpress 500W - $10 - [4]
• 200W 8x8, $13 - [5]

Silicone Rubber Sheet

• Silicone rubber sheet - 20x20", 1 mm - $10 - [6]
• McMaster - <$5/sf for 1/32" thick - [7]

Double Sided Tape

• $3/sf - [8]

Single Sided Tape

• Kapton tape, 4"x100ft - $25 - [9]

• Enough for 300 small beds (4"), or 33 12" beds.

Coated Nichrome Wire

• Need 30 Ohms of wire, about 10' long
• See Nichrome Wire

Uncoated Nichrome Wire

• Need 30 Ohm resistance for the length of wire at 120V to get 480W, for P=IV, V=IR, I=V/R -> P=V^2/R = 120^2/30 according to Electrical Power Calculator.