Laser Engraver on 8 Bit

From Open Source Ecology
Revision as of 07:46, 20 June 2019 by Marcin (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
  • An 8 bit processor is fine for laser cutting, but needs good understanding to work for laser engraving (more processing required)
  • Calculations are needed to determine max feed rate using an 8 bit processor - calculations show feed rates of ___ mm/sec.
  • The dumb solution is to go to 32 bit, but it would be useful to press 8 bit processors to do the same

Links