D3D Simple Kit Preparation

Product

1. Ship extruder wire bundle prepared, terminated, in split wire loom
2. Ship extruder parts complete, thermistor and heater tested. No tapping required, but full assy required.
   1. Easy Build Kit - already assembled and tested
3. Ship axes with motors with pulleys already on. Customer builds the axes from start to finish. Tape detail on X and Z axes.
4. Controller components are pretested for functional LCD. RAMPS assembled but without heat sinks. Motors tested. GFCI wired. Power supply tested. Endstops and probe tested.
5. Board precut.
6. Bed magnets glued
7. D3D Pro, CNC Torch Table included on SD card or USB stick.

Kit Preparation Instructions

Extruder Wire Bundle

1. Take 6 components
   1. Probe - remove nuts
   2. Heater cartridge
   3. Thermistor
   4. Motor wire
   5. Fan
   6. Blower
2. Terminate them
   1. Put triple plug on probe
   2. Ferrule the heater ends
   3. Ferrule the blower
   4. Ferrule the fan
   5. (Nothing for thermistor and motor wire