Felix Makori Log

Thu Dec 11, 2025

Felix Module Build Data

• Se [1]

Quality Control Points - Site Visit

Once you bring the module on site, we will verify the following. The purpose is to determine the uniformity with which applicants can produce modules and if that depends on the build experience of the applicant:

1. Fastener schedule - 12" in the field (mid stud), 6" on the four edges

    - Yes - Fasteners on edges of OSB board started 6" (inches) out from any given corner. 

1. Total number of fasteners used

    - 74 nails.

1. How much does the OSB stick out at maximum on each edge? ##Right edge:

     - No "stick out" - Flush-(0")

1. How much does the OSB stick out at maximum on each edge? ##Left edge:

     - No "stick out" - Flush-(o")

1. How much does the OSB stick out at maximum on each edge? ##Top edge:

     - 3/8" Over

1. How much does the OSB stick out at maximum on each edge? ##Bottom edge:

      - 3/8" Under

1. Actual dimensions of the wall module - based on your documented measurements. This evaluates the inaccuracy of dimensional lumber when sourced in different locations - or whether the module has expanded/contracted due to moisture or shipping. This helps us to adjust for any necessary quality control based on irregularities of lumber sourcing. ##Width: _____4ft_____Height:____10ft_____

1. 1. Cross diagonal distance between corners - bottom left and upper right corner:

     - Inner (inside corner) - 9' and 6"
     - Outer (outside corner) - 9' and 9.75"

1. Cross diagonal distance between corners - - and bottom right and upper left corner:

     - Inner (inside corner) - 9' and 6.75"
     - Outer (outside corner) - 9' and 10.75"

1. Thickness: (should be about 6" thick, but document this please)

     - Left - 5" and 7/8th"
     - Right - 5" and 7/8th"
     - Top - 5" and 7/8th"
     - Bottom - 5" and 7/8th"

1. Actual dimensions of the OSB - length and width and thickness -

     - 9'x4'

1. Please rate yourself on the scale of 1-10 for build speed and effectiveness. We will attach a score to your result according to a mutually defined scale - where you and OSE collaborate on determining what each level (1-10) should require - and you will score yourself accordingly. 10 is a perfect result (within 1/8" absolute tolerance everywhere for all parts). A point is taken off for every mis-tolerance or long time to build. There is currently no minimum score that would be required for acceptance, as long as there is strong evidence that you would be able to correct any mistakes or make continuous improvement in the future.

     - Note: Using hand tools and nails caused the build time to increase drastically. Another increase in time came from an attempt to correct the slight overhang/underhang in the OSB on the top and bottom of the          frame.
     - Score: 7

Wednesday Nov 26, 2025

Future Builders Academy Application: Step 5 - Build Test

Build Test results: (should be 9+9 +3*19=75)

Future Builders Academy Application: Step 5 - Build Test Video: OSE Apprenticeship Wall Module Build - Time Lapse

Step 5 - Build Test Pictures: Future Builders Academy Application - Step 5 Build Test - Pictures

Step 5 - Build Notes: Build Notes

Nov 4, 2025

Interview -

Sunday Oct 26, 2025

Written Application:

Here is a direct link: Felix Makori Written Application

Friday Oct 24, 2025

Here is my Video of Interest:

Wed Oct 22, 2025

Uploaded and sent Video of Interest (VOI) into [Future Builders Academy - Video of Interest Submission Form]. User: Felix Makori VOI