CEB Press/Manufacturing Instructions/Valve Mount

Main > Housing and construction > CEB Press > CEB press building instructions

=Part Information

The valve mount holds the hydraulic solenoid valves to the primary arm.

Tools

• Hole puncher with 13/16" Dies

• Drill Press with 5/16" or larger bit.

Materials

• Steel plate 1/4" x 6" x 12"

• Solenoid Valve Set

Steps

• Set the steel plate on a flat surface

• Position the solenoid valve set over the plate such that its work port surface is flush with the top edge and square with the side edges of the steel plate.

• Using the marking utensil and the center punch, mark then center punch the 4 aligned holes at the sides of the steel plate

• Drill 4 holes of 5/16" diameter at the marked points of the steel plate

• Punch 2 holes of 13/16" diameter that are centered 20cm from each other and 3cm from the bottom edge of the steel plate.