Cold Saw/V1 Design Files/Clamp Block

From Open Source Ecology

< Cold Saw‎ | V1 Design Files

Revision as of 22:54, 7 June 2012 by YK (talk | contribs) (→‎Clamp Block)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to navigation Jump to search

Clamp Block

Length: 50mm

Width: 25.4mm

Height: 25.4mm

Jaw Hole Diameter: 10.5mm DIA then M12x1.75 Tap

Jaw Hole Height: 13mm

Jaw Hole Spacing Along Length: 30mm

Jaw Hole Notes: The fastener hole is closer to the center of the vise so that a jaw of the same slot length can move closer to the center of the clamping volume. Also, the fastener hole being closer to the center of clamping volume increases rigidity of the clamping center because the fastening compression occurs closer to the center.

2D Image

3D CAD STP

File:ColdSawV1ClampBlock.stp

2D Fabrication Drawing PDF

File:ColdSawV1ClampBlock.pdf

2D Fabrication Drawing DXF

File:ColdSawV1ClampBlock.dxf

Retrieved from "https://wiki.opensourceecology.org/index.php?title=Cold_Saw/V1_Design_Files/Clamp_Block&oldid=64918"