Pololu
Jump to navigation
Jump to search
Intro
Pololu is a stepper motor driver.
Versions of Pololu
- The DRV8825 stepper motor driver carrier is a breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver. The module has a pinout and interface that are nearly identical to those of our A4988 stepper motor driver carriers, so it can be used as a higher-performance drop-in replacement for those boards in many applications. The DRV8825 features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/32-step). It operates from 8.2 – 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling). - [1]
Comments from Kliment @Reprap IRC
- I still think if you are only using 2.5A steppers on RAMPS then you should rather go with a drv8825-based design. That would be a drop-in for RAMPS. The ones I designed are available at https://github.com/kliment/cooldrv, GPLv3 licensed, and can be purchased at
They can definitely manage a 2.5A stepper with microstepping. Since their BOM cost is in the single-digit dollars, I definitely recommend you try them first. Their current control is at 0.25V/A, so you want to set them to 2.5A*sqrt(2)/2*0.25V/A = 0.44V. Remember, for a 2.5A stepper with microstepping, you only need sqrt(2)/2 of its max current in each coil, so 1.77A for a 2.5A stepper. The ones from Pololu are closed source and have slightly worse thermal design, but they should be able to keep up with your steppers too.