Ironworker/Manufacturing Instructions
Jump to navigation
Jump to search
Introduction
See Ironworkers for introduction.
Build
We start the build of the open source ironworker with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate.
Initial CAD, not finished:
You can download the file here.
Design v0.1
Bill of Materials
- 5"x8" hydrauilic cylinder
- [2]1"x4" pin - for mounting cylinder
- [2]3/4" or 1" washers
- [2] 1"x10"x48" plate - main parallel pieces