Initial Testing Producedure

Testing Procedure

Upload firmware to the RAMPS board.
Turn power supplies on, make sure green light turns on.
Verify that the fan is turned on on the extruder
Power light lights on the Arduino
Fan turns on on the 24V power supply.
Verify that red light on MOSFET turns on
Move axes by hand to see there is no stuckage
Moving axes by hand, record the range of movement for X, Y, and Z - ______________
Home x
Home y
Home z - but don't adjust probe yet.
Set extruder temp to 205C
Verify that red light goes on, and that the temperature on the Cura monitor is flat (stable) once temperature is reached.
Load filament
Extrude filament once machine gets up to extruder temperature
Home X and measure range of motion from beginning up to software endstops. Compare X motion via the Cura interface and the maximum motion obtained in Step where axes are moved by hand to determine their absolute highest motion. The difference should be +/- 3 mm
Home Y and measure the same for Y. Motion tolerance should likewise be +/- 3 mm
Touch the head of the inductive sensor, and see if it is triggered (red light on it should turn on).