CEB Press/Manufacturing Instructions/Wide Cylinder Supports

From Open Source Ecology
< CEB Press‎ | Manufacturing Instructions
Revision as of 08:16, 13 December 2011 by Bkufa (talk | contribs) (Created page with "thumb|left|The "monster" wide cylinder supports thumb|The "normal" wide cylinder supports #For the "Norma...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search
The "monster" wide cylinder supports
The "normal" wide cylinder supports
  1. For the "Normal CEB," torch 3/4" holes in the angle for the cylinder supports in the same manner as with the horizontal members.(19" apart, 3/4" diameter)
    • For the monster, don't worry about the holes, you'll mag-drill them later.
  2. Weld the 2"x2" angle (5.75") centered and squared on one side of the U-Channel(for "monster") or angle (for "normal", weld it to the side without the holes).
  3. Torch a hole (3/4" for "normal") (1" for "monster") away from the end of the 2"x2" for a 3/4" bolt and grind it clean.
  4. Place a steel nut over the hole and insure it is clear for a bolt and flush.
  5. Weld the nut in place.
  6. Put a galvanized nut on a 3/4"x2.5" bolt and thread through the welded nut on each side.
Retrieved from "https://wiki.opensourceecology.org/index.php?title=CEB_Press/Manufacturing_Instructions/Wide_Cylinder_Supports&oldid=47912"