CNCCMV2/Structure/Blocks

Fabricate Platform

• 

• File:PlatformV2.pdf

• Qty=1

• Mark all holes using 2 datum edges in the L-shape.

• Drill all holes

Fabricate X Major Block

• 

• File:XMajorBlockV2.pdf

• Qty=2

X Major Block 1

• Mark all holes for the first block, noting the datum edge orientation.

• Drill all marked holes for the first block, but for the stepper shaft hole use a 1/8" dia bit instead of 22mm.

• Check compatibility between the first block and the stepper motor.

• Tap the required holes.

• Drill the stepper shaft hole to its correct diameter AFTER all X and Y Blocks are complete.

X Major Block 2

• Mark all holes except the stepper mount and shaft holes.

• Drill all marked holes.

• Match drill the stepper mount and shaft holes from X Major Block 1 to X Major Block 2, using the 12mm dia 200mm lg support shaft for alignment of the support shaft holes.

• Check compatibility between the second block and the stepper motor.

• Tap the required holes.

• Drill the stepper shaft hole to its correct diameter.

Fabricate X Minor Block

• 

• File:XMinorBlockV2.pdf

• Qty=2

X Minor Blocks 1 and 2

• Mark all holes except the leadscrew hole.

• Drill all marked holes.

• Match drill the leadscrew hole from X Major Block 1 (stepper shaft hole) to X Minor Blocks 1 and 2.

• Tap required holes.

Fabricate Y Minor Block

• 

• File:YMinorBlockV2.pdf

• Qty=1

• Match the Y-axis thru holes with Y Major Block and Z Mount Block

• Mark all blind holes

• Tap holes as necessary

Fabricate Y Major Block

• 

• File:YMajorBlockV2.pdf

• Qty=1

• Mark all blind holes and remaining thru holes

• Tap holes as necessary

Fabricate Z Minor Block

• 

• File:ZMinorBlockV2.pdf

• Qty=1

• Match all thru holes with Z Major Block, Z Mount Block (both ends), and End Mount Block

• Tap holes as necessary

Fabricate Z Major Block

• 

• File:ZMajorBlockV2.pdf

• Qty=1

Fabricate Z Mount Block

• 

• File:ZMountBlockV2.pdf

• Qty=1

• Mark all blind holes

Fabricate Spindle Block

• 

• File:SpindleBlockV2.pdf

• Qty=1

• Match the mounting thru holes with End Mount Block

• Tap holes as necessary

Fabricate End Mount Block

• 

• File:EndMountBlockV2.pdf

• Qty=1

• Mark all remaining blind holes

• Tap holes as necessary