Talk:D3D CNC Torch Table

From Open Source Ecology
Revision as of 03:57, 8 November 2017 by Dorkmo (talk | contribs) (Created page with "=Design Change Suggestions= ==Flat Bar== I think it would be straight forward and beneficial to add a piece of flat bar (sized about 1/4" x 6") from end to end of the long a...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Design Change Suggestions

Flat Bar

I think it would be straight forward and beneficial to add a piece of flat bar (sized about 1/4" x 6") from end to end of the long axis. the sliding part could be tweaked to add a roller bearing to support it self from the flat bar. could bolt a piece of angle iron near the bottom to prevent flexing if needed. --Dorkmo (talk) 04:57, 8 November 2017 (CET)


D3dcnc-changes2.png


D3dcnc-changes1.png

Retrieved from "https://wiki.opensourceecology.org/index.php?title=Talk:D3D_CNC_Torch_Table&oldid=161128"