Hydronic Stove Video Script

From Open Source Ecology
Revision as of 22:12, 30 December 2017 by Marcin (talk | contribs)
Jump to navigation Jump to search

The main house heating system in the Seed Eco Home is the Hydronic Stove - a wood burning stove with a water pipe heat exchanger. The hot water is circulated in PEX pipes under the floor, providing comfortable heat - no cold feet.

The main parts of the heating system are the stove itself - the heat exchanger on the top part of the stove - the chimney for exhaust gases - and the PEX tubing under the floor. Here's how it works.

The stove generates heat. The heat exchanger - or more specifically - 16 sections of 1" black pipe - captures the heat and transfers that heat to water that is circulating through the pipes. The water then circulates the heat through the house. There are 4 coils of tubing, each 300 feet long, under the main floor. We are using 1/2" PEX. For the heat exchanger, we are using pipe elbows to make the connections. When you do that, use thread tape and pipe dope both - the pipe dope makes it much easier to screw the fittings on to avoid leaks. We did not use pipe dope. I had many leaks, which I sealed with JB Weld high temperature epoxy by pasting over the leaking joints. The joints are outside of the stove. The reason is ease of build - and access for serviceability. Because you don't know if you will have leaks until you actaally run the system at temperature. As the joints are outside the stove, they don't get hotter than the water temperature. To seal the air holes around the pipes, we welden on a collar and stuffed it with rock wool insulation. Rock wool, unlike fiberglass insulation, can take the heat of a stove. The heat exchanger has a total of 16 square feet of area, or an estimated 200,000 BTU.

The stove door is hinged and closes with a latch. A circular opening on the door allows either a blower - to get more heat - or a pellet burner attachment that shoots pellet heat into the stove. As such, this stove can run either on pellets or firewood. We plan on installing an open source pellet burner before winter ends. Underneath the door is an ash tray.

The pumping and control of the system is done through the open source Hydronic Control Panel.



Future additions to the hydronic stove will include a pellet burner, as shown in the Seed Eco-Home Infographic. A pellet burner is more efficient - and it allows for automated operation. If you have a big hopper full of pellets - you may not need to load the stove several times per day - but instead - you go days or even weeks - depending on the size of your wood pellet hopper.