Turbine Fabrication
The turbine fabrication procedure starts with a 1.5” shaft. Sourcing: part # 8920K312 at McMaster Carr. Cost: $15
The turbine fabrication is almost wholly symmetrical for the two sides, except for the provisions for exhaust. The side with the exhaust has two features that the other side does not have: a main working gas seal and the exhaust manifold. Look at the picture of the exhaust end:
Both sides have bearings, spacers, seals, and clamping collar. Find a bearing to fit the shaft and slide it on the shaft. Sourcing: part 60355K84 at [1] for $38 or [2] for $9, or Ebay for $20 each.
Also, find a spacer, with 1.5 inch ID and 1/8” wall. It is 1/4” long + width of seal (see seal design drawing). Sourcing: ______ Cost:
Also, find a seal to match the spacer. 1.75” ID and 3” OD.
Find end pipe section to house the bearing, seal, and spacer. Sourcing: ____ . Cost:
Find 5/16” plate steel for end side of turbine. Sourcing: ____ . Cost:
Begin work on the other shaft end. Start with ball bearing. Sourcing: ____ . Cost:
Begin work on the exhaust compartment. Use a larger pipe section to house the exhaust holes. Sourcing: ____ . Cost:
Cut out exhaust port and weld on an exhaust pipe. Sourcing: ____ . Cost:
Lathe out another end plate. Sourcing: ____ . Cost:
Install middle pipe section. Drill small holes into end plates to bind sections together. Use gasket sealing compound for vapor-tightness. Sourcing: ____ . Cost:
