Sara Bajor Log
Mon Sep 6, 2018
Installed Linux: GIMP, Arduino, Cura-Lulzbot
Mon Sep 3, 2018
Initial BOM on Paper for D3D v18.09
Thu Aug 2, 2018
Slide deck - [1] view only, copied to [2]
July 19, 2018
Developer Test Work Log
http://img.youtube.com/vi/UWhZ_YS_Y-8/default.jpg
Media:Sara-bajor-xyz-cube-bolt-initials.fcstd
Installing Linux USB: .5 hours Learning FreeCAD: 15 hours Documentation: 1 hour
Learning FreeCAD was definitely the most difficult task. The 15 hours learning FreeCAD enabled me to complete the XYZ cube in about 42 minutes. It took me a while to figure out how to align the pipes perpendicular and parallel to each other within the xyz plane. I watched the 2 tutorial videos provided but had to frequently reference the Old_FreeCAD_Tests to fully understand how to accomplish the task. I did not use any other outside tutorials.
I believe I built the XYZ cube in a "brute force" fashion and that a more efficient and elegant solution was possible. At some point while adding the fastener to my cube, some of the pipes came out of position, so I give myself 85% for this attempt.