D3D v20.04.27 Data Collection

Build

• For the bed, because bed holder carriage nut catchers are printed upside down, best way to smooth is using a longer bolt to suck in a nut to clear the excess plastic. Possibly a different production engineering (machine redesign or part redesign) can solve the dirty nut holes

Bed Lift Capacity

• Bed itself is about 27 lb:
  • 17x17" -1/16" plate
  • 9' of 2x1/16" strip = all of 1/16" is 10 lb
  • one 1/8"x18"x18" plate = 11.4 lb
  • Rods - 2 lb (8' of 8 mm)
  • Insulation -

Run

• RAMPS 1.4 doesn't handle 2+2 series+parallel z motors. It is fine to drive 2 in series - bed lifts. Adding the other side just causes skipped steps.