Basic Calculations
Protocol
Hint:
- Use Calculations Template - you can make a copy of it or include just the relevant quantities.
- Document your work at a wiki page named MachineName_Calculations
- Use Presentation Template to explain your calculations with pictures and diagrams. Embed this on the MachineName_Calculations wiki pag. For simple calculations, take pictures of backs of envelopes, your note sheets, screencasts, etc - that show basic quantifications. Use whatever is relevant to quantify what you are working on.
About
Calulations are importance for reasons of determining performance. They are also used in product literature to show useful product specifications.
Scaling Calculations are calculations that also consider scalability. These calculations include all relevant physical, mechanical, fluid, electrical, chemical, thermal, static, dynamic, aerodynamic, acoustic, optical, hydrological, nuclear, structural, and other properties that allow a machine to be effective for a particular purpose. Scalability is emphasized because a single design should be adaptable to different scales of operation via Intensive and Extensive Scalability. Calculations include both parameters and calculations based on these parameters.
Comprehensive List with Links to Online Resources, etc
- Motor Torque based on power
- Nichrome Wire Calculator
- Pulley Calculator
- Solenoid Force Calculator
- Solar Angle Calculator
- Magnet Force Calculator
- Cycling Power and Speed Calculator
- Cost of Living
- Triangle Calculator
- Motor Speed Calculator
- Hydraulics Calculators
- Chain Lenght Calculator
- Steel Plate Weight Calculator
- Bolt Weight Calculator
- Nut Weight Calculator
- Metals Weight Calculator
- Steel Weight Calculator
- Basic force, torque, stress limit calculations
- Center of Mass + Weight
- Range of Motion Design calculations
- CAE analysis for structural failure, fatigue, deformation, crash testing, abrasion, thermal properties, and others
- Cost
- Beam deflection
- Expected lifetime
- Basics Statics calculations according to Basic Statics Calculations Procedure
- Expected maintenance cost according to Maintenance Cost Template
- Performance/power/speed/lifetime/lift/etc.
- Precision calculations - what precision of motion is achieved in devices
- Tolerancing requirements
- Hydraulic fluid flow and pressure
- Basic static loads analysis of mechanical devices
- Rotation speeds
- Bending forces
- Shear strength limits
- Thermal loss calculations
- Thermal profiles - FEA
- Geometrical optics
- Torque calculations
- Rotational inertia
- EMF calculations
- Thermal mass calculations
- Combustion calculations
- Embodied energy calculations
- etc.
These calculations should be performed for all critical components of machines, even though the aim is not Value Engineering. In the case over-building of components for purposes of lifetime design, calculations are relevant for providing accurate assessment of safety factors and performance expectations independent of empirical performance data.
A list of desired calculations or data points should be produced for each machine. Note: a spreadsheet or education page should be included to give a crash course on each calculation for the benefit of a novice who has a working knowledge of secondary-level
Spreadsheet
The typical calculations for consideration are: