D3D Pro v23.12 Troubleshooting and Repair

Print & Maintenance Log

{{log|date=|time=|note=}}

---

2024/06/26 | 11:23pm

• Pen Case

---

2024/06/25 | 11:11pm

• Failed - Lost Z Steps

2024/06/25 | 11:07pm

• Pen Case - Homing failed

2024/06/25 | 3:29am

• Pen Case - Failed - underextrusion (?)

2024/06/25 | 2:58am

• Pen Case - good start (?). Paused for filament strip. Am I printing too fast? Good again after pause. Nevermind - failed on filament stripping.

2024/06/25 | 2:52am

• Pen Case - Failed - Z randomly losing steps during initial heatup.

2024/06/25 | 2:21am

• Pen Case - Failed - Z offset too high.

2024/06/25 | 2:05am

• Failed - stripping. Recaptured bed mesh

2024/06/25 | 1:59am

• Failed - stripping. Adjusted Z offset.

2024/06/25 | 1:58am

• Failed - Y axis skewed.

2024/06/25 | 1:55am

• Failed - X homing. Endstop rotated and was angled too low.

2024/06/25 | 1:20am

• Bj. S. P. 2 - Paused at start for stripped filament. Failure - stripping, bed leveling(?)

2024/06/25 | 1:13am

• Bj. S. P. 2 - 0.2mm layers - Failed - nozzle too close to bed. Forgot to set correct Z offset and save to EEPROM (again).

2024/06/25 | 1:11am

• Bj. S. P. 2 - Moved to 0.2mm layer heights from 0.3mm to reduce throughput. Failed - probing.

---

2024/06/24 | 11:49pm

• Bj. S. P. 2 - Failed - nozzle too close to bed - filament stripped. I forgot to save the previous bed offset; live adjusted Z to compensate and attempt recovery. X axis belt clamp is too low - damaging prints. Failure - Bed adhesion, underextrusion, filament stripping.

2024/06/24 | 11:46pm

• Blackjack Shoe Plate 2 - probing failed, bed misaligned

2024/06/24 | 11:43pm

• Failure to heat bed - M112 error

2024/06/24 | 11:38pm

• R.T.T.P. - turned off linear advance @ ~10% - Print looking okay at 60% - some underextrusion early on. Print successful! Horizontal artiface appears in a repeating pattern every 7mm. (Primarily cosmetic issue). Printed this model in incorrect orientation

2024/06/24 | 11:11pm

• R.T.T.P. - Paused @ skirt for stripped filament. Failed @ 5-10%. Stripped filament

2024/06/24 | 11:08pm

• R.T.T.P. - Speed too high? Seemingly exceeding max volumetric flow rate. Failed - underextrusion

2024/06/24 | 10:45pm

• Ringing tower test print - Cancelled - Forgot to adjust min. layer time

2024/06/24 | 10:24pm

• Ringing tower test print - Cancelled - Print speeds not high enough - Polymaker PLA Black