Assemble H-arms

Main Arms

• [2] Cut 4-1/2” piece of 1-7/8” DOM.
• [2] Cut 3-1/2” piece of 1-7/8” DOM.
• Mark position of loader shaft for diameter of DOM.
• Torch loader shaft, considering that 1-7/8” DOM gussets are used.
• Measure location of loader arms on frame.
• Torch loader arm location in frame.
• Place gussets in tractor frame.
• Fit 1-7/8” shaft through gussets.
• [2] Mount 1-7/8” washers outside of frame and inside of arms.
• Insert DOM gusset into loader arm.
• Mount 1 loader arm at a time onto the shaft.

Cross Arms

• Cut 54" cross arms.
• [4] Cut 1/2"x4"x6" angle - 6" long.
• Drill 3 holes on long side and 2 holes on short side.
  • Long side goes on cross arm, shoft side goes on main arms.
• Measure location for mounting of cross arms on the main arms.
• Fit and clamp the cross arm in place.
• Transfer punch hole locations on one side of loader arms.
• Take loader arms off one by one.
• Mark other side of cross arm-mounting bolt locations.
• Annular cutter mag drill through main arms.
• Remount main arms
• Fit cross arms and bolt them on, using metal lock nuts.